Heart & Industry

Home · Electronic components · Pimoroni

STEMMA Wired Potentiometer Breakout Board - 10K ohm Linear

STEMMA Wired Potentiometer Breakout Board - 10K ohm Linear

Pimoroni

£2.58

Price read from Pimoroni on 2026-10-22. Check before buying.

For the easiest way possible to measure twists, turn to this STEMMA potentiometer breakout (ha!). This plug-n-play pot comes with a JST-PH 2mm connector and a matching JST PH 3-Pin to Male Header Cables - 200mm, so wiring up is a cinch. Simply plug the cable in, then use the black wire to connect to your ground, white wire to the input/signal pin and the red wire to your power pin. The power pin voltage should match the voltage max of your analog input. So, if you're using a 5V Arduino or compatible, connect red to 5V. If you're using a 3V Feather board, tie red to 3V. TECHNICAL DETAILS PCB Di

Pimoroni's own words, read from their page.

Buy from PimoroniOut of stock. Price seen 2026-10-22. Not an affiliate link, we earn nothing from it.

Where this comes from

The part other shops don't tell you. Three separate questions, kept separate on purpose, each with its source.