Heart & Industry

Home · Single-board computers · Pimoroni

RP2350 Stamp

RP2350 Stamp

Pimoroni

£10

A hand-solderable RP2350A module with 16MB FLASH, LiPo charging, reset/boot buttons, and all GPIO broken out. The Stamp was created to allow you to use the Raspberry Pi RP2350A in your designs without having to solder small-pitch QFN chips or worry about lots of external circuitry. All you need to get you started is a 5V supply or a LiPo battery. The Stamp will take care of the charging and switching the power sources. The castellated edges with 2mm pitch can be hand-soldered directly to a Carrier board, used with pin headers for more flexibility, or connected without soldering using FlexyPins

Pimoroni's own words, read from their page.

Buy from PimoroniPrice seen 2026-09-05. Affiliate link.

Where this comes from

The part other shops don't tell you. Three separate questions, kept separate on purpose, each with its source.