Heart & Industry

Home · Pimoroni

Particulate Matter Sensor Breakout (for PMS5003)

Particulate Matter Sensor Breakout (for PMS5003)

Pimoroni

£2.75

A handy-dandy breakout that converts between the picoblade connector cable on the PMS5003 particulate matter sensor and a standard male 2.54mm pitch header. Use this breakout to connect a PMS5003 particulate matter sensor straight to your Raspberry Pi (or other microcontroller) with some female-to-female jumper jerky , using our PMS5003 Python library to read data from the sensor. Connect the pins on the breakout to the following pins on your Raspberry Pi: 5V to 5V GND to ground TX to BCM 14 RX to BCM 15 RESET to BCM 27 EN to BCM 22 You can also use this breakout with Raspberry Pi Pico (and ot

Pimoroni's own words, read from their page.

Buy from PimoroniPrice seen 2026-09-05. Affiliate link.

Where this comes from

The part other shops don't tell you. Three separate questions, kept separate on purpose, each with its source.