Power Support Tool
Locusrite
Price not listed
The new Power Support tool is designed to be used in both SDS and SDS Plus hammer drills. The bodies and pin are manufactured from 34 CrNim06 to ensure durability. It is then heat treated to 45/55 Rockwell. An ergonomic handle is fitted for ease of use. Available in: 8mm, 9mm, 10mm. To use: Attach the Power Support Tool into the SDS chuck. Ensure that the drill is set to hammer action only. Put the tie into pre-drilled pilot hole. Let the hammer action on the drill drive the tie fully home. The spring action on the tool will allow for the tie to be set 10mm below the surface.
Locusrite's own words, read from their page.
Buy from LOCUSRITE LIMITEDPrice seen 2026-09-19. Not an affiliate link, we earn nothing from it.






